Oil Filter location?
I just did a test drive on the 2023 U11 (I own a 2014 E84).
I popped the hood to check for the oil filter location but wasn't able to see the oil filter location. The E84 oil filter is really handy up on top.
Where is the U11 oil filter located? I prefer to do my own oil/filter changes.
Last edited by COOLGREANY; 05-29-2023 at
09:14 PM
..
Do-It-Yourself information for the modifications I've completed
Do-It-Yourself information for essential wear and tear items
Articles covering all the ways to maintain your car
All about the BMW 330ci
Various links that I've found valuable
A few pictures of my car and some others
Warning!
The information provided at "Bmw330ci.net" web site is "as is" with all faults and without warranty of any kind, expressed or implied, including those of merchantability and fitness for a particular purpose, or arising from a course of dealing, usage or trade practice. "Bmw330ci.net" web site nor it's owner/creator, can not and does not provide any warranty, expressed or implied, about the accuracy or use of information found on "Bmw330ci.net" web site. The user assumes that risk.
THE USE OF THIS INFORMATION IS FOR YOUR REFERENCE ONLY. BMW330CI.NET AND ITS OWNER/CREATOR DISCLAIM ALL LIABILITY FOR DIRECT, INDIRECT, INCIDENTAL, OR CONSEQUENTIAL DAMAGES OR INJURIES THAT RESULT FROM ANY USE OF THE EXAMPLES, INSTRUCTIONS OR OTHER INFORMATION ON THIS PAGE.
Difficulty
Changing your oil isn't difficult at all. You just need a little patience and about 30 minutes of spare time (if you're taking your time).
How often to change your oil
BMW recommends you change your oil roughly every 15000 miles. If that sounds like a high number to you then your right! I don't buy into this at all, but I do hold that synthetic oil can last long past 3000 miles. Therefore I change my oil every 6500 miles, which is a happy medium. Choose your mileage and stick with it.
Parts Needed
BMW OEM Oil Filter Kit (BMW P# 11-42-7-512-300) $6
7 Quarts of Mobil One 0W-40
Plastic Bag
Tools Needed
17mm and 36mm Sockets
Microtorque Wrench (Capable of going from 5-25 ft-lbs is a good)
Oil Drain Pan (Make sure it can hold 7+ quarts)
Safely lift the front of the car and make it level if possible
1. Using a lift or a floor jack with jack stands or ramps lift the car. Instructions for jacking up your car can be found here. This can be a very dangerous step, so make sure that the car is properly secured before ever getting under it. Never get under a car that is just supported by a jack!
Locate the oil drain plug and drain the oil
Locate the drain plug and drain the oil
1. Open the hood and open the oil filler cap on the top of the engine.
2. Using a 17mm socket, remove the oil drain plug. Make sure you position the oil drain pan so that the stream of oil is collected when it first gushes out. To let it fully drain try and make the car level and give it 15 minutes or so to properly drain out.
New OEM oil filter kit
Loosen the oil filter cap
Using a plastic bag remove the old filter
Loosen the filter cap and remove the old filter
3. Using the 36mm socket, loosen the oil filter cap under the hood.
4. Remove the cap and using a plastic bag, pick up the filter and remove it. This step will help prevent you from dripping oil everywhere.
Install the new crush washer
Install the new crush washer on the drain bolt and reinstall it
5. Remove the old crush washer and put the new crush washer on.
6. Once the oil has finished draining (slightly dripping if at all) thread the drain plug on by hand. Using a microtorque wrench, tighten the plug bolt to 18 ft-lbs.
Install the new gasket
Tighten back down the cap
Remove and install the new oil filter housing gasket
7. Using a small screwdriver, carefully remove the old gasket from the oil filter cap.
8. Get some new oil and lubricate the new gasket from the kit. Then carefully slide it down where the old one was attached. It will ride in the groove as shown in the picture.
9. Place the new filter where the old one was and push down till it is properly positioned (it won't move around very easily).
10. Place the cover down and start tightening it by hand. Finally tighten it down with a microtorque wrench to 18 ft-lbs.
Add the new oil
Add the new oil
11. Carefully add about 6.5 quarts of oil to the engine. Once you have finished this, check the dipstick to make sure that there is oil showing up on the dipstick. (If there isn't any make sure that it isn't under the car).
12. Put the oil filler cap and start the car up to examine for leaks. The red oil light should go off after about 1-2 seconds. If it doesn't turn off the car immediately because this means something has gone wrong.
13. Return the car to the ground (take it off of the lift/ramps/jack stands) and check the level to ensure that it is a little over half way on the dipstick.
14. Enjoy 6500 miles of spirited driving before the next oil change.
It's a really easy job that anyone can do. Never take your car to the oil change place down the street. Take pride in your car and make sure it has the proper blood flowing through its veins. Rest assured that the job was done properly!