Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:
Standard Practice for Leaks Using the Mass Spectrometer Leak Detector or Residual Gas Analyzer in the Tracer Probe Mode
1.1 These test methods cover procedures for testing and locating the sources of gas leaking at the rate of 4.5 X 10 -14 mol/s (1 X 10 -9 Std cm3/s) or greater. The test may be conducted on any object to be tested that can be evacuated and to the other side of which helium or other tracer gas may be applied.
1.2 Three test methods are described:
1.2.1 Test Method A -For the object under test capable of being evacuated, but having no inherent pumping capability.
1.2.2 Test Method B -For the object under test with integral pumping capability.
1.2.3 Test Method C -For the object under test as in Test Method B, in which the vacuum pumps of the object under test replace those normally used in the leak detector.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. A specific hazard statement can be found in 19.2.
Bell jar leak test; Bomb mass spectrometer leak test; Helium leak testing; Leak testing; Leak testing-mass spectrometer leak detector (MSLD); Mass spectrometer leak detector (MSLD); Mass spectrometry; Probe methods; Residual gas analyzer (RGA); Tracer probe mode; Vacuum testing; leak detection-using the mass spectrometer leak detector/residual gas; analyzer in the tracer probe mode, test,; Sealed object mass spectrometer leak test; leak detection-using the massspectrometer leak detector/residual gas; analyzer in the tracer probe mode, test,;Order Form; ICS Number Code 19.100 (Non-destructive testing)
03.03 (Nondestructive Testing)
19.100 (Non-destructive testing Including testing equipment: industrial apparatus for X-ray and gamma radiography, penetrant flaw detectors, etc. Non-destructive testing of welded joints, see 25.160.40 Industrial radiographic films, see 37.040.25 Non-destructive testing of metals, see 77.040.20)
Standard Specification for Chromium and Chromium-Nickel Stainless Steel Plate, Sheet, and Strip for Pressure Vessels and for General ApplicationsStandard Specification for Chemical Passivation Treatments for Stainless Steel PartsStandard Specification for Seamless, Welded, and Heavily Cold Worked Austenitic Stainless Steel Pipes